Waterpark Simulator Where Is The Water Gun Guide

Overview

The water gun in Waterpark Simulator is a tool you use to extinguish guests who catch fire in the sauna area. It is not a weapon or a maintenance item — it exists specifically for the sauna fire quest.

Direct outcome: By following this guide, you will locate the water gun, complete the sauna fire quest, and earn credit for extinguishing a burning guest.

Key facts:

• The water gun is required to complete the sauna fire quest.
• Only extinguishing with the water gun counts toward quest progress.
• The sauna must be set to maximum temperature to ignite a guest.

Requirements

Before you can use the water gun, you need:

1. A sauna built and operational in your park.
2. The water gun unlocked. The exact unlock method is not documented in the available evidence. Player reports indicate the water gun becomes available as a tool you can equip, but the specific unlock requirement (level, currency, or quest progression) could not be verified from official sources.
3. A guest willing to use the sauna. Guests will not enter the sauna if the temperature is already at maximum.

Note: If you have not yet unlocked the water gun, check your quest log or build menu. The available community reports do not specify the exact unlock condition.

Steps to Use the Water Gun

Follow this sequence to complete the sauna fire quest:

Step 1: Wait for a Guest to Enter the Sauna

• Keep the sauna temperature at a normal level.
• Watch for a guest to walk inside the sauna building.
• Do not rush this step — guests enter on their own schedule.

Step 2: Crank the Temperature to Maximum

• Once a guest is inside, open the sauna temperature controls.
• Set the temperature to maximum.
• The guest will catch fire after a short delay.

Step 3: Equip the Water Gun

• Open your tool selection or inventory.
• Select the water gun.
• If the water gun is not in your inventory, verify you have met the unlock requirements (see Requirements section).

Step 4: Spray the Burning Guest

• Aim at the guest who is on fire.
• Spray them with the water gun until the flames go out.
• Quest progress should register immediately.

Step 5: Reset the Temperature

• After extinguishing the guest, lower the sauna temperature back to normal.
• This allows the next guest to enter the sauna.
• Repeat the process if you need to complete the quest multiple times.

Common Mistakes

Leaving the Sauna at Maximum Temperature

Problem: If you set the sauna to max and leave it there, guests will not enter.

Fix: Always keep the temperature at normal until a guest is inside. Only then crank it up.

Using Another Method to Extinguish

Problem: Other extinguishing methods (if any exist) will not count toward the quest.

Fix: The quest only registers when you use the water gun. Confirm you are spraying with the water gun and not another tool.

Spraying Too Early

Problem: You spray the guest before they actually catch fire.

Fix: Wait until you see flames on the guest before using the water gun. Spraying a non-burning guest does not count.

Advanced Tips

Optimize the Cycle

The fastest approach reported by players:

1. Wait for a guest to enter the sauna.
2. Set temperature to max.
3. Watch for the fire animation.
4. Spray with the water gun.
5. Immediately lower the temperature.

This minimizes downtime between attempts. If you need to extinguish multiple guests, repeat the cycle rather than leaving the sauna at max.

Watch for Guest Behavior Patterns

Guests may avoid the sauna if the temperature is too high for too long. Keep the sauna at normal temperature when not actively completing the quest. This encourages consistent guest traffic into the sauna.

Combine with Other Maintenance Tasks

While waiting for a guest to enter the sauna, you can handle other park maintenance. The guest will remain in the sauna until you adjust the temperature, so you have time to multitask without missing the window.

Frequently Asked Questions

Where exactly is the water gun located?

The water gun is a tool you equip, not a physical object placed in the park. It is available from your tool selection menu. The exact unlock condition is not documented in available player reports.

Can I use the water gun for anything else?

Community reports mention using the water gun to clean toilets and hose down smelly visitors, but these uses are not confirmed in the available evidence. The primary documented use is extinguishing burning guests in the sauna quest.

Why won't my guests enter the sauna?

If the sauna temperature is already at maximum, guests will avoid it. Set the temperature back to normal and wait for a guest to enter before increasing it.

Does the water gun run out of water?

There is no evidence in the collected material indicating a limited water supply. The water gun appears to be usable without refilling, but this could not be verified from official sources.

Related Guides

• Waterpark Simulator: Where Is the Chlorine
• Waterpark Simulator Achievement Guide
• Waterpark Simulator: How to Change Appearance
• Waterpark Simulator Demo Guide